Performing Webslinger Mod

Tools needed:

•  Phillips #0, #1, #2
• Diagonal cutters
• 4mm Allen wrench

1. Cover tank with protective towel or blanket

 

2. Remove plastic chrome meter bezel using 4mm Allen wrench.  Remove 2 front, 2 rear 4mm button head bolts.  Careful not to lose the rear rubber grommets or front metal collars. 

3. Using long-reach Phillips #2 screwdriver, remove two truss head screws (one each side) connecting meter unit to handlebars.  Left side note: carefully remove zip tie affixing wire bundle to holder with diagonal cutters.

4. Remove the following six Phillips #1 screws. (Do not remove two recessed or wire bundle stay.)
1. Four around unit perimeter (one top, three bottom)
2. Two at upper corners
3. Black plastic housing will come off.  Careful not to lose the rubber seal between the two halves.

 

5. Pull off speedometer needle.

6. Remove two speedometer dial screws using a Phillips #0.  Pull off OEM dial face and set aside; it will not be reused.

7. Place custom dial face in unit, secure with the two Phillips #0 screws.  Be sure to remove any fingerprints or smudges before securing.

8. Reinsert needle and key ignition to “ON” position, allowing needle to sweep. Note where needle lands and readjust if necessary by removing and reinserting needle.

9. Reinstall the housing with the six Phillips #1 screws (4 perimeter, 2 corners). Be sure black rubber seal is properly seated.

10. Reinstall meter unit from underneath with the 2 truss head screws.

11. Reinstall plastic chrome meter bezel using 4mm Allen wrench.

12. Go for test ride, and enjoy!